Slurry Transportation
Replacement of HDPE Pipe for Pexgol
Case Study Nº
36
Customer
Tizapa Mine
Mexico
|
2015
Working Conditions
Pressure 100 Psi; Flow 225 mД/h; Specific Weight 1.2 t; Solids 20-30%.
Pexgol Pipes
Pexgol 10” 250 mm, Class 15 (SDR 11).
Application
Slurry transportation.
Lenght
200 meters.
Categories
The Challenge
Tizapa Mine formerly installed an HDPE line were they used to transport slurry. This pipe suffered several failures on the joints, so did the thermo-fusions and the stub-ends as well.
They determinate that the failures were caused by small water hammers on the line.
Pexgol Solution
Due to this special circumstances, Tizapa Mine decided to install Pexgol pipes for the following reasons:
- Supplied in long lengths coils: Of 100 meters each, reducing possible failures in the joints.
- It high resistance to water hammers.
- Burst pressure: 3 times higher than nominal pressure.
- Safe joints: They don’t deform neither detach caused by a pressure surge.
- Quick installation: Coils were uncoiled in 1.5 work hours, without any complex equipment.
Hot Water Distribution for Solar Technology
Raygen
Australia
|
2021
Pexgol Pipes for Efficient Wastewater Transport
Paladini
Argentina
|
2022
Overcoming Installation Hurdles and Enhancing Operational Efficiency
Newmont
Argentina
|
2022
