CONNECTING PEXGOL PIPES WITH FLARED ENDS

Home » Resources » Manuals » Connecting Pexgol Pipes with Flared Ends

The flared-end connection is suitable for both hot and cold media. Special Fixpoint clamps should be used before and after the flared ends. Flange material is carbon steel A37. Other carbon steel or stainless steel grades can be ordered.

In case of subzero temperatures, special restraining techniques should be employed to prevent pulling out of the flared end from the flanges.

No gasket is needed when connecting two Pexgol pipes with flared ends and flanges or when connecting a Pexgol pipe with a flared end to a flanged fitting.

Tighten the bolts evenly around the flange until all the bolts are all tight.

If torque wrenches are applied, use the recommended values in the following table. Tighten the bolts evenly using 75% of the recommended torque values and then tighten to the final value.

No retorquing is necessary in the flared ends of Pexgol pipes!

Tightening torque values for Pexgol flared ends:

Pexgol Pipe Dia. Flange size Bolt dia. Torque N x m Torque ft x lbs
Min. Max Min Max
63 2” 5/8” 16mm 34 48 25 35
75 2 ½” 5/8” 16mm 34 48 25 35
90 3” 5/8” 16mm 48 68 35 50
110 4” 5/8” 16mm 48 68 35 50
125 4” 5/8” 16mm 61 88 45 65
140 6” 3/4“ 20mm 68 100 50 75
160 6” 3/4“ 20mm 68 100 50 75
180 6” 3/4“ 20mm 68 100 50 75
200 8” 3/4“ 20mm 108 163 80 120
225 8” 3/4“ 20mm 108 163 80 120
250 10” 7/8“ 22mm 108 163 80 120
280 10” 7/8“ 22mm 108 163 80 120
315 12” 7/8“ 22mm 142 217 105 160
355 14” 1” 25mm 244 370 180 270
400 16” 1” 25mm 244 370 180 270
450 18” 1 1/8“ 28mm 270 405 200 300
500 20” 1 1/8“ 28mm 270 405 200 300
560 22” 1 1/8“ 28mm 352 530 260 390
630 24” 1 1/8“ 28mm 395 590 290 435

We are ready to provide you with a quote for your project.

Start typing and press Enter to search