INSTALLATION INSTRUCTIONS FOR SADDLES
Note the following data for installing Golan brass saddles, electrofusion saddles and Krausz stainless steel saddles to Pexgol pipes.
Please note: Install all saddles onto the pipe prior to drilling the outlet hole.
Dimensions of drills for outlet hole in brass saddles
|Dimensions of drills for outlet hole in brass saddles|
|Brass saddles dimensions||Thread||Diameter and drill type|
|50x¾”||Male||22mm hole saw tooth|
|63x¾”||Male||19mm hole saw tooth|
|63×1″||Male||24mm hole saw tooth|
|63×2″||Female||45mm hole saw tooth|
|75×1½”||Male||35mm hole saw tooth|
|75×2″||Female||45mm hole saw tooth|
|90×1½”||Male||33mm hole saw tooth|
|90×2″||Female||45mm hole saw tooth|
|110×2″||Female||45mm hole saw tooth|
|160×2″||Female||45mm hole saw tooth|
- Saddles up to 63 mm – 11 mm wrench
- Saddles 75 mm and 90 mm – 14 mm wrench
- Tighten the saddles until the two halves meet.
Dimensions of drills for outlet hole in stainless steel saddles
|Dimensions of drills for outlet hole in stainless steel saddles|
|Outlet type||Outlet size||Drill type||Drill diameter|
|Female outlet thread||1½”||Hole saw tooth||40|
|Female outlet thread||2″||Hole saw tooth||51|
|Flanged outlet||2″||Hole saw tooth||40|
|Flanged outlet||3″||Hole saw tooth||70|
|Flanged outlet||4″||Hole saw tooth||92|
|Flanged outlet||6″||Hole saw tooth||140|
Install electrofusion saddles of all manufacturers (Plasson, Friatec, GF/Wavin) and Plasson mechanical saddles according to the manufacturer’s instructions.